8 data and parity using HSERIN, HSEROUT

[Dave]

Smity42, Use the command DEFINE HSER2_BITS 9 to setup the hardware serial uart for 9 bit transmittions and then use DEFINE HSER2_ODD or HSER2_EVEN to set the parity state. Its all in the manual....

Dave Purola,
N8NTA

[Smity42]

Hi dave,

thanks for your help. I was looking at the HTML manual (http://www.melabs.com/resources/pbpmanual/) and it has no mention of the HSER_BITS define at all, and I have no idea where my printed manual has got to. So I checked the PDF one and found it. Thanks muchly

Martin