How about an online Syntax checker? Or something that could at least count the amount of code you used and suggest a suitable PIC for the job? Or perhaps let you know if what you've done will even fit into the PIC you specify? I'm not asking for FREE answers, just a sanity check. I would like to know if what I'm doing will fit into the PIC I've chosen so I can go on and lay out a PCB. I'm thinking of something similar to Advanced Circuits' DFM service that will analize your Gerbers and tell you if you have DRC problems.
Something like that would be very helpful while waiting for your development bundle to get through the purchacing department. While I wait all I have is Notepad and the PicBasicPro manual and the PIC datasheets.
Besides that, I would add that most of those that use these forums do what others CAN'T, and therefore get what others only wish for... job satisfaction