Servo control woes

[Acetronics2]

Hi, Eris

Bad news ... I copied and pasted your code, just changed portB N°s as required here ... put a 6LR1 cell ( there's a regulator on the board !!! ) and a futaba servo.

Every thing goes as you programmed it : the led blinks and the windscreen wiper does its job ...

The problem is not ( no more ... humour ) in your code ...

So, What to do ??? ...

First verify your servo supply ( good common ground w/Pic ... enough current to feed the servo ...)

Second verify the signal lead of the servo ... servo behaviour smells no received signal !!!
In that way I would recommend you !!! SOFORT !!! to add a 1k resistor between Portb.0 and your servo connector.

I keep the line
Alain