PDFSUSB.exe source

[Normnet]

File compare shows a valid file uploaded.

Norm

[Dong]

I've got the source files you posted above.
And compiled&rebuilt the project successfully.
It runs ok.

Thanks a lot.

[paketorro]

I have downloaded the files and I have found that there is still some header files missing regarding with Controls of the DemoTool page. In my case these file are not so necessary, since I just want to build a simple application for downloading HEX files, so I have deleted them.

Now I can successfully compile the project with Borland Builder 6.0 but there is still a linker error: [Fatal Linker Error] Fatal: Unable to open file 'VCWB6.LIB'

Can anyone help me, since I am not used to Borland Builder. If anyone can post the source files for Visual Studio will be fine as well.

Thanks.

[Dong]

You need to install TMS Instrumentation Workshop in your bcb6.0.

[dlchambers]

Thanks to Hunter2 for posting the ZIP of the PICDEMUSBFSDemoTool source.
It's done in Borland C++ Builder, so I ported it to VC++.
Details here: http://www.dlwrr.com/electronics/picdem/index.html

[sjpast]

Now I can successfully compile the project with Borland Builder 6.0 but there is still a linker error: [Fatal Linker Error] Fatal: Unable to open file 'VCWB6.LIB'

I'm currently working on recompiling and building the PICDEMUSBFSDemo software project with C++ Builder 2007. I've installed the TMS Software from the link above for Builder 2007 (although the installation locked at the very end). I'm also getting the error pertaining to VCWB6.lib. I've searched my hard drive for this library but cannot find it, I've also tried googling for it although end up unsuccessful. Is this library even required for what I'm doing, or should it have installed with the installation of the Instrumentation Workshop software? I'm really new to all this, I appreciate any help.

Thank you

[sjpast]

I'm currently working on recompiling and building the PICDEMUSBFSDemo software project with C++ Builder 2007. I've installed the TMS Software from the link above for Builder 2007 (although the installation locked at the very end). I'm also getting the error pertaining to VCWB6.lib. I've searched my hard drive for this library but cannot find it, I've also tried googling for it although end up unsuccessful. Is this library even required for what I'm doing, or should it have installed with the installation of the Instrumentation Workshop software? I'm really new to all this, I appreciate any help.

Thank you

Ok, never mind. Thanks to dlchambers for his work with the visual studio route, I've been able to accomplish what I've needed using that rather than the original code with Borland.