Instant Interrupts - Revisited

[ScaleRobotics]

Yes, it is asking you to change the include file here:

wsave   VAR BYTE    $20     SYSTEM      ' location for W if in bank0
;wsave   VAR BYTE    $70     SYSTEM      ' alternate save location for W 
                                         ' if using $70, comment out wsave1-3

' --- IF any of these three lines cause an error ?? ---------------------------- 
'       Comment them out to fix the problem ----
' -- It depends on which Chip you are using, as to which variables are needed --
wsave1  VAR BYTE    $A0     SYSTEM      ' location for W if in bank1
wsave2  VAR BYTE    $120    SYSTEM      ' location for W if in bank2
wsave3  VAR BYTE    $1A0    SYSTEM      ' location for W if in bank3

It needs to be adjusted for a few different chips. Comment out the wsave at $20, and uncomment the wsave at $70, and try commenting out the wsave1-3.