|
Ok, I disabled that code to disable/enable the USBSERVICE interrupt before the gosubs and now the interrupt is getting executed a LOT of times.
I can't say at what interval, but the counter is scrolling on the LCD pretty fast. The hundreds are going by just a bit faster than every second, but I still lose connection.
Darrel, how can I adjust the speed of the interrupt?
Robert
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
|
I'm going to solder a wire to 1 pin, blink that pin in the interrupt and connect my scope on the wire.
I don't know much about scopes, but I might be able to figure out the frequency.
Robert
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
Members who have read this thread : 8You do not have permission to view the list of names.
Posting Permissions
Bookmarks