Communication PIC to PIC?

[Rhatidbwoy]

ok. I think that I have found a way to get this moving. The problem that I have is that I broke my 16f648a and do not have another. I will be waiting for a while. But between what I have I think that it will work.

I have the programs of my work if you want to look. ironing out the little details to trans u2 ver 7 and still working on trans u1 ver2.

Ah quick question. the attachment MATH is part of u1 ver2. I am getting error leaving me to understand that I don't understand the math behind what is happening within the chip. Since I am doing multiplication and division my information is base 32 rather than 16? Is that what I am to understand?

[peterdeco1]

Very crude but it works. A while back I had to send 1 of 8 numbers to a slave PIC. I used SOUND command on master & COUNT command on slave. First number was near 100HZ, 2 was 200HZ, etc. Worked perfectly. Count command was limited to 100ms and allowed fast response. Count command needs a "window" like IF PULSESRECEIVED > 8 and < 12 THEN LET X = 0. Hope this helps.

[mister_e]

for your math you can't use float directly like that.

0.5 * x ===> still the same if you divide by 2

If x=1.5 ===> you should multiply by 10 then read IF x=15 depending of the previous math...

Well you should think integer than float.