reading, writing, and displaying from eeprom

[Rhatidbwoy]

The problem that I am having is that I would like to read from the eeprom and then display it on a LCD screen. What I have done first was to print the screen to how I want the information to be seen on the LCD then to follow I would read the information on the eeprom. After reading the eeprom and putting the data into predefine variables it would be displayed. All of this can be seen in the Tranmitter ver 7.txt ( this starts under ther label of CHANNELS).

Then when I move from line to line I would do the same thing over by reading what line number/channel number then write this information back into the eeprom.

The problem that I am having is that I know or presume that the commands that I have written are correct but am not getting what I would like to get on my LCD screen. What i get is the same value that I start out with will stay for any channel and menu selection that I have. The only way that I can change the value is inc or dec the value or to turn off the micocontroller.

Is there any help or suggetions that anyone can give.

Thank You