PWM on PIC16F88

[ntege]

hi ya am surely one lucky guy.i know i might me asking for alot but can u please send the schematic for the adc code. by the way am called gonza, am from uganda in eastafrica.its like am one of the very few people in my part of the world dealing with microcontrollers.its really cool stuff i must say...... thanks alot for the support i appreciate it.

[mister_e]

There's no real difficulties here, LED cathode goes to GND, anode goes to a resistor (200-300 ohm) lead, and the other resistor lead goes to the PIC PORTB pins. repeat it 8 times.

pot ( <10K ) wiper goes to the AN0 pin (PORTA.0), one pot side on gnd, the other to Vdd.

Not much!

[ntege]

okay mate am going to try that.

[ntege]

hey the code works very well. thank you. pliease help me with sample code for reading and writing to the eeprom.plays with leds. thanks

[mister_e]

Don't push your luck too much you should have some code example in the datasheet?

[Bruce]

And when you find a spare moment;

I need code in binary please & full schematics in Protel format please to measure the speed of sub-atomic dark matter particles in a vacume, as they pass through a 1/2 eaten snickers bar, at -900 degrees kelvin, on the dark side of the moon, 10+E1200 meters from the event horizon of a black hole, at full moon, in the 3rd cycle. Can you help?

No hurry. I have 12 minutes before my ship departs....;o}

[mister_e]

that's easy, just enter the tunnel with your ship and read it, you should have plenty of time to write it on a little piece of paper.


Sorry... i don't have Protel on my VIC-20 as my dog chew the audio tape of that software