Alfat Sd/mmc

[PaulBarter]

Thanks for that,

I have ordered the ALFATSD board but it'll be a couple of weeks to get to New Zealand. I am planning on using UART in text mode since my application is a simple serial logger.

I've also looked at the proton basic stuff and it looks helpful but I won't know how helpful until I dive into the actual project.
I was hoping you or eoasap had a bare bones PBP program to get me started since I'm not using the proton development board.
Perhaps when I get my chip I'll cobble one together and may re-post if I hit a brick wall. I'm still a bit of a newbie but have had pretty good sucess with serial comms on these chips already. the only unkown is writing this serial data to a text file. Thanks again for the timely reply.

[Ron Marcus]

As far as getting text from Alfat, if you know the length of the text string, you can assign a variable array to Alfat's response. Call it Alfat_response.
Let's say you block out 60 bytes to the array. When you use serin2, you can declare,in statement, (Alfat_response\4) the \4 means serin2 will get four consecutive bytes from the input pin. I don't have the book, so syntax is up to you. The display sequence would be to create a loop and LCDout the characters using the loop counter to increment the array

For loop = 0 to 3 ; One less since we start from zero
LCDOUT (Alfat_response[loop])
Next loop

Now, if you don't know how many characters are coming out of Alfat, do the loop, and time it out after 10 milliseconds. Keep in mind that some characters will not print to the LCD. You may have to use 'DEC' or 'HEX' to make any sense of them.

That's all for now,
Ron

[PaulBarter]

Hello again:

I got my Alfat SD board and have made an attempt at getting it to go but with limited success.

Attached is a PBP program that should reset the ALFATSD and then list the files/folders on the card using text mode.

When I run it, all I get as replies from the ALfat are null characters (Dec 0). It doesn't go to the error routine (except once), so I'm pretty sure the connections are good. Note that I'm using B5-7 rather than B0-2.

I'm still a bit of a newbie when it comes to this stuff so any suggestions on how to get this to go would be gratefully accepted. Also, feel free to tell me how crap I am at programming, I've got a pretty thick skin.

I thought the file list would be the simplest way to ensure I was communicating properly but if there's a simpler way to show on the LCD that things are working then let me know.
TIA

-Paul

[Ron Marcus]

Hey Paul. You should look at the Proton+ routines on the GHI website. They gave me some excellent insight into timing that the GHI docs were sadly lacking in. After powering up the board, do a hard reset by bringing the reset pin to gnd, then let it float by making the associated pin an input. Do not use weak pullups on portB at this point. The reset routine for proton is what I followed. Next, if all is well, you should see a "BL". This will tell you the bootloader is ready to either load the Alfat firmware, or update it. At this point send "R" or "RS" ? Check the Alfat docs on this. You should get the Alfat startup message complete with version number. If you get this far, you're 3/4 of the way there....
Ron