koossa, Yes you will, This is the proven circuit used by many of us and it will also allow you to connect other equipment at a later time. Good luck...
Dave Purola.
N8NTA
|
koossa, Yes you will, This is the proven circuit used by many of us and it will also allow you to connect other equipment at a later time. Good luck...
Dave Purola.
N8NTA
|
Thank you DAVE!!!
|
Is the Polarity of the 1uF capacitor on Pin 6 of the Max232 the correct way arround?
|
Yes.
Its the smoothing capacitor for VEE the internally generated NEGATIVE supply voltage
Keith
www.diyha.co.uk
www.kat5.tv
|
I upload the HEX file (16F877_04.hex) to my PIC using the Picstart plus, I have changed the settings in MPLAB as follow:
<img src="http://www.picbasic.co.uk/forum/attachment.php?attachmentid=656&stc=1&d=1134568334 ">
Is this correct?
|
Please help!!
I have changed my Schematic to look exactly like the one below and have uploaded the 16F877_04.hex with Picstart plus and MPLAB, then in Microcode studio plus I select Microcode Loader as my Programmer and changed the "ICD Serial Port" dropdown to COM2. From the menu I have then select "Project","Compile and Program".
It then pops up with a dialog box "Reset Required, Please reset the target microcontoller...." I have then press the reset button on my circuit, but the dialog box just stays there which means nothing happened.
I have measured the voltage between MCLR and GND and it is 5v?
<img src="http://www.mecanique.co.uk/code-studio/loader/reset-circuit-small.gif">
|
What OSC speed are you running at?
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks