When I get up to speed with Eagle Cad, I intend to use http://www.batchpcb.com. They are geared towards the hobbyist market.
When I get up to speed with Eagle Cad, I intend to use http://www.batchpcb.com. They are geared towards the hobbyist market.
Wisdom is knowing what path to take next... Integrity is taking it.
Ryan Miller
I make my own using a laser printer, a copy of time magazine, and iron and some etching compound.
check out this link for detailed destructions:
http://www.fullnet.com/u/tomg/gooteepc.htm
This method is very good for prototypes or when you only need 1 or 2 pcbs. It works out MUCH cheaper!
how well does that work? that does seem like a really cheap, fast, and convenient way to make (small) boards from home.
it works very well... ive used the method to make over a dozen boards and they all turned out perfect... the trick to making sure it works is not to skimp on the iron... make sure the printed page and board get nice and hot.
Last edited by Kamikaze47; - 30th November 2005 at 14:31.
I use Eagle for the board artwork, and Injectorall to print the board. I had little success with iron on, and my consistency was lousy. The photo process is more difficult, but the the results look professional, board after board.
Ron
For the dinky few I make in a year I used the photocopy method as well. I bought "special" paper from Digi-Key at the time to do it. I haven't done enough of them yet for them to look 100% perfect (meaning some of the lines were a bit jagged), but it is cheap to do for making a few prototype boards where looks might not be a big issue.
I checked out that Kamikaze47 listed and I think my next ones will be better using the tips there.
Bart
Bookmarks