hyperterminals commands

[santamaria]

i would like to know some commands to sent from pic to hyperterminal like clear screen e.t.c


thanks

[Dave]

santamaria, I use VT-100 commands for terminal control. If you do a search for VT-100 commands you will find quite a list. Here are some control codes I have used in the past to control ternimals connected to my products:
' ************************************************** ********
INITS: 'INITIALIZE TERMINAL

CLRS:
SEROUT2 TX1,TX1BAUD,[27,91,72] 'HOME CURSOR
SEROUT2 TX1,TX1BAUD,[27,"[1J"] 'CLEAR SCREEN
RETURN

************************************************** ********
POSITION: 'POSITION CURSOR ON LINE & COLLUM
SEROUT2 TX1,TX1BAUD,[27,91,"H"]
SEROUT2 TX1,TX1BAUD,[27,91,DEC LINE,";",DEC COLLUM,"f"]
RETURN

Dave Purola,
N8NTA

[santamaria]

thanks for your quick answer.i check this commands that you post and working fine.i will search it for more commands.

santamaria

[Darrel Taylor]

Hi santamaria,

ANSI codes for Hyperterminal
http://www.pbpgroup.com/modules/wfse...hp?articleid=9
<br>

[ptig185]

Darrel,
I included your ansi.inc file and tried a compile but mpasm gave errors.

sonmething about "found label after column 1" and
a few illegal charcters.

I'm using pbp in Microcode studio and Mpasmwin.

I only included the .inc file and did not use any of the macros.

thanks,
Brian

[Darrel Taylor]

Hi ptig185,

Make sure you have at least 1 HSEROUT statement in your main program.

The include file uses the HSEROUT?C macro's, but it doesn't uses an HSEROUT itself. So PBP doesn't include the HSEROUT?C macro unless you have an HSEROUT statement somewhere in your program.

HTH,