anyone using SpeakJet ?

[Kamikaze47]

Just to make sure, I take it you have the following connections?

- pins 1-4, and pins 6-9 (E0-E7) connected to ground
- pin 5 (Gnd) connected to ground
- pin 10 (RCX) connected to the PIC I/O pin (and also grounded via 47k resistor)
- pin 11 (Rst) connected to +5v via a resistor
- pin 12 (M1) connected to +5v via a resistor
- pin 13 (M0) connected to ground
- pin 14 (V+) connected to +5v

*edit* if you have some code you are trying, post it and ill have a look

[sapteka]

Yes, it works. I have tried this. See more at http://www.sapteka.net/pic16f877andspeakjet.htm
Regards,
Sapteka