Hardware Flow control serial communcations

[sporker]

By looping you mean to connect cts to rts? Do you think that would eliminate the "flow control"

I have some max232 chips that I can use also, but do they support/implement hardware flow control? I couldnt see anything on that from the datasheets. Why do you think I would need multiple I/O's if I will just read/write to rts&cts with 2 ports on my pic.

Any inside on this topic would be a temendous help. Thanks for your time!

-Alan

[arniepj]

Yes,looping means to connect rts to cts with the hope of eliminating the flow control.
I wasn't thinking ,but the max232 should be enough to do the job.Remember the max232 is to convert the pic output to the 232 voltage spec only.One output for xmit data ,one output for rts,one input for rx data,and one input for cts.You will need to determine the flow control logic.Basically you will output a rts(pic) to cts (Yamaha) to get data from the Yamaha.And vice versa to receive data from the pic.To know for sure exactly what to do,experiment with a pc first.I use a program called simple terminal (http://www.bb-elec.com/product.asp?sku=simpterm) free from bb-electronics.With this program you can manually toggle the rts and observe what happens.

[Ioannis]

Be carefull looping the rts-cts pins. If there are more than one byte to send or receive the slave may loose some of them. Your receiver is not a PC!

BTW, recently I bought the RX-V1500 receiver. Do you know where can I find the info's about the serial control?

Ioannis