How about this one?
Looks like a diode. Tried to take pics all around by bending lead, not sure if I got them all.
I used 3x zoom, then cropped as much as possible.
I don't see anything...
How about this one?
Looks like a diode. Tried to take pics all around by bending lead, not sure if I got them all.
I used 3x zoom, then cropped as much as possible.
I don't see anything...
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
Possibly older version of the 1N4148 or 1N914 signal diode. If the body is bulkier, could be ancient germanium diode
Is that glass or clear plastic? It looks like a fuse or a diode.
![]()
"No one is completely worthless. They can always serve as a bad example."
Anonymous
I bet it is a germanium diode.
You can confirm it by applying say 10 volts with a 10K resistor and measure the voltage drop on the part pins. If it is around 0.2-0.3 volts the you can be sure for that.
Ioannis
I'm thinking germanium too, but even then, google seems to believe there isn't a standard bar code.
They look an awful lot like theses guys:
https://www.ebay.com/itm/125030406073
I still have to test the voltage.
(I'm cutting plexi right now)
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
I had to have a quickie look. Used 2 meters on diode mode and got these readings:
Is the top one measuring resistance (339)?
And is the bottom one measuring voltage (0.282)?
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
Bookmarks