Great! Just confirm it counts correctly now.
Ioannis
|
Re: Solved - ELAPSED TIMER: TimerConst not defined
Great! Just confirm it counts correctly now.
Ioannis
|
Re: Solved - ELAPSED TIMER: TimerConst not defined
It compiles, but now I have to find the correct value.
I'm now on Art's thread trying to find that out:
https://www.picbasic.co.uk/forum/sho...020#post156020
EDIT: Darrel talks about the Prescaler and adding NOPs here:
https://www.picbasic.co.uk/forum/sho...9649#post69649
And that's about where my eyes start glossing over. I had also read a comment (somewhere) about Darrel using a prescaler of 2 for 64MHz, so I'm pretty sure I'm on the right track.
EDIT SOME MORE: For future me when I'm looking for the same answer, Prescaler is controlled in T1CON.
Last edited by Demon; - 23rd August 2024 at 01:37.
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
|
Re: Solved - ELAPSED TIMER: TimerConst not defined
Ok, I couldn't figure out how to incorporate Prescaler in Art's formula, so I took another route:
- used Preload from 16MHz
- set Prescaler to 1:2
Counter on LCD worked as expected.
https://www.picbasic.co.uk/forum/sho...025#post156025
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
|
Re: Solved - ELAPSED TIMER: TimerConst not defined
Art's formula with Prescaler:
65535 - (((( MHz / Prescaler ) / 4 ) x 10000 ) - 8 )
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
Members who have read this thread : 1You do not have permission to view the list of names.
Posting Permissions
Bookmarks