How is this?Originally Posted by pedja089
|
Re: Determining trace/via/wire current capability
How is this?
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
|
Re: Determining trace/via/wire current capability
I went one further using vias after adding cooling; grounding the VSS pin on the voltage regulator with 3 large vias.
This way it doesn't mess up the smaller vias I have on signal traces and VSS pins on tiny SMD ICs.
CORRECTION:
These are labelled backwards. The 7805 uses the TO-263 package and the Hexfet uses D2Pak (in my project).
Last edited by Demon; - 30th July 2024 at 01:36.
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
Members who have read this thread : 1You do not have permission to view the list of names.
Posting Permissions
Bookmarks