I usually put a heartbeat LED on a PIC before I start doing intense coding; just to make sure my CONFIG is set up right.
500mSec ON
500mSec OFF
That way it's relatively closer when you count along with it.
|
Re: How do I check my crystal's operation/configuration?
I usually put a heartbeat LED on a PIC before I start doing intense coding; just to make sure my CONFIG is set up right.
500mSec ON
500mSec OFF
That way it's relatively closer when you count along with it.
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
Members who have read this thread : 1You do not have permission to view the list of names.
Posting Permissions
Bookmarks