Both images have number 1 on the left pad, so I assume you are right.
Ioannis
|
Re: LED pinout question
Both images have number 1 on the left pad, so I assume you are right.
Ioannis
|
Re: LED pinout question
Well, turns out JLCPCB probably made that EasyCAD drawing. There's no pinout in the datasheet. So they most likely just looked at how the LED is packaged on the reels and made an arbitrary decision as to which pin is what.
If you want to follow some drama on LED pinouts, you can read my thread over here (this is the other place I go to get balanced information on general electronics material):
https://forum.allaboutcircuits.com/t...an-led.201924/
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
|
Re: LED pinout question
The absolutely necessary notation is the A and K in a diode. Numers are arbitrary and no one forces you to identify A as 1 or 2.
So the design of the part by JLCPCB seems OK to me and I would not bother more on this.
Ioannis
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks