And if you want this metal bracket be earthed, if it is not on the electric circuit, how can you do it.
Ioannis
|
Re: KiCad - free PCB design tool
And if you want this metal bracket be earthed, if it is not on the electric circuit, how can you do it.
Ioannis
|
Re: KiCad - free PCB design tool
I should have added a pic. I was talking about the metal supports that don't go through the PCB. The RK097 pot has 2 (bottom left unit), the 2 other through-hole supports are grounded:
https://ae01.alicdn.com/kf/Sd244b8c1...4ef397562P.jpg
I know the switch will be secured, but I can't leave a support "rub" against traces. A metal burr could potentially cut through the epoxy protective layer.
It's just easier to avoid tracing through that area, than have to deal with some "freak untraceable ground" on a trace.
I try to plan so that any student/intern could assemble these without requiring keen observational skills.
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
|
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks