My previous example for viewing your eeprom data for verification was a bit abbreviated, and wouldn't work as stated. So here it is in a more usable form.
Code:
DEFINE HSER_TXSTA 20h   ' enable RS232 transmission
DEFINE HSER_BAUD 19200  ' set to required baud rate on your system

eeadr con 100       ' set to eeprom address for data of interest
eedata var byte     ' eeprom data storage

getdata
    Read eeadr,eedata               ' retrieve data byte from eeprom
    For x = 2 To 0 Step -1          ' extract 3 digits for display
    eedata = (eedata DIG x) + $30   ' convert to "decimalized" ascii number
    Hserout[eedata]                 ' send ascii out RS232
    Next x                          ' do it for all 3 digits of byte
With this code added to your program, you can send out, and verify the value of any byte stored in your internal eeprom as a decimalized 3 digit number (readable on any RS232 terminal program).