Tips and tricks

[Demon]

Just be warned, the sheet isn't exactly 8x10in.






I didn't measure first and started cutting. I could have gotten at least 31 separators of 1x2in, but I only got 27 cause I wasn't paying attention to cutting that last slice in the other direction.




There's 1/6in plexi available to simulate the real separators, but it's a bit thicker to cut and I don't think it's worth it.

1mm plexi only takes 3 good slices, bend and you get a clean break, then pass an exacto in the bend to slice off the other layer of protective film. At worse, take 4 slices if you don't want to press hard.