Do PICs goto sleep?

[Ingvar]

After looking at the HiRK-433 datasheet(assuming this is the one you use http://www.okwelectronics.com/datasheets/DS.0010-2.pdf ), i say that there is no need for pulldowns(or ups). Just make sure your JP1 and 2 are not linked. This would make the outputs latching, you want them to be momentary.

/Ingvar

[Tissy]

Yup, thats the exact one.

Ok, i'll remove the pull-down resistors.

It must be something else that is making the CASE ELSE statement true then.

Cheers,

Steve

[arniepj]

When I am developing a project I always have a serial port available ,even if the project will not use it.Being able to check variables and ports is invaluable for debugging,versus debugging blind.

[Tissy]

OK, i'm ready for a slap !!

I failed to put a pull-up on the MCLR port. The thing is, i put it on my diagram, but failed to put it on the vero circuit.

Thanks again to all those that helped. I did solve another a couple of issues at the same time. So all was not wasted.

Regards,

Steve

[Ingvar]

Here comes the ruler ......... Nah, that's to easy on somebody who forgot something as serious as a pullup on MCLR. It's time for Melanie to get into her leather outfit and teatch you real good, that way it'll surely never happen again. It might, however, make me want to forget all about resistors .... and their proper use