...When the switch is at ground, the HC14 sees the voltage divider of two 10K resistors, so the voltage is at 2.5Volts.
...
I would strongly recommend to increase the 10K pull up to 100K.
Ioannis
I'm going to test this using 10K pull-up and a 1K res and see what that turns out (I'd like to do the math, but my hair hurts ).
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
Bookmarks