Hello.
I got some MBI5026, with LEDs connected to it's output. I want to turn them on via PBP.
According to datasheet, the following timing diagram should be used. I tried to use it with the code below,but it does not works. I have OE connected to GND, so this should not be an issue?
Code:SDI VAR PORTC.4 CLK VAR PORTC.5 LE VAR PORTC.6 CONT VAR WORD FOR CONT=0 TO 65535 LCDOUT $FE,$C0,"VAL=", DEC CONT SHIFTOUT SDI,CLK, 0, [CONT] HIGH LE PAUSE 1 LOW LE PAUSE 10 NEXT
Bookmarks