Hpwm @ Pic16f777

[NavMicroSystems]

fuhr3r,

since you are new to the forum you should have a look at THIS

[fuhr3r]

Hi, the code is very big, almost 8k and commented in portugueese

This PIC have 2 pins for CCP2, selected with the fuses, so does it need the DEFINES?

[fuhr3r]

DEFINE CCP2_REG PORTB ' Hpwm 2 pin port
DEFINE CCP2_BIT 3 ' Hpwm 2 pin bit

Now HPWM 2 works, but HPWM3 still not working.

I tryed DEFINE CCP3_REG PORTB and CCP2_BIT 5, but did not work. (only CCP has 2 choices of pins).

Tomorrow i will try simulate with MPLAB or put a LCD showing CCP3CON.

Nobody ever used 3 HPWMs?

[fuhr3r]

http://www.picbasic.co.uk/forum/showthread.php?t=1770

"Nope. The HPWM command only supports 2 channels. CCP1 & CCP2. You
would need to modify the 16F library to support CCP3. It's much easier to
just configure hardware PWM manually."

Problem solved....