display lcd variable array Ascii

[volcane]

I don't know that there is a short hand way to do that. In the past I have either made the string ASCII via addition or written one byte at a time to the lcd.

BTW I tend to use DEC variable in place of # variable.

not there are other solutions?

[DynamoBen]

Do this....it works great.

For idx = 0 to 7
LCDOUT $FE, 1, #var[idx]
next idx

[sean-h]

lcdtest var byte[3]

lcdtest(0)="1" 'ASCII value for 1
lcdtest(1)=$32 'HEX value for 2
lcdtest(2)=51 'DEC value for 3

'Cear Display and Output to line 1
LCDOUT $FE,1,str lcdtest\3

Will display 123 on LCD.

Regards

Sean.

[volcane]

Thanks to all however I have resolved using the commando lookup

[volcane]

lcdtest var byte[3]

lcdtest(0)="1" 'ASCII value for 1
lcdtest(1)=$32 'HEX value for 2
lcdtest(2)=51 'DEC value for 3

'Cear Display and Output to line 1
LCDOUT $FE,1,str lcdtest\3

Will display 123 on LCD.

Regards

Sean.

hello!

which it is the difference between:

I2CREAD SDA,SCL,pag1,0,[str password\4]
LCDOUT $FE,1,str password\4

it is

for ind_ep = 0 to 3
I2CREAD SDA,SCL,pag1,ind_ep,[password[ind_ep]]
pause 20
next ind_ep
LCDOUT $FE,1,str password\4

[DynamoBen]

You don't need to pause when reading an I2C buss. You only really need a pause when writing to it.

Both examples are functionally the same. The first one is much easier to ready.

[Nitro]

couldnt you just say
lcdout "var="
?????