Help with PIC 12F683 bit confituration in PBP3

[mpgmike]

Either method works, however, placing your CONFIGs in your code lets you debug issues better. If something doesn't work, and the problem lies with your CONFIG settings you set up a program time (with the pop-up window), how would you know??

[dw_picbasic]

Thanks - good wisdom!

However, I'm not familiar with setting up a program time (with the pop-up window)

[mpgmike]

When you go to program, the Programmer window pops up. Under View/Configuration you can view your CONFIG options similarly to MPLABX. There are quite a few neat features in the header tabs. You ought to play with it and get to know your tool. Charles walked me through it several years ago.

[dw_picbasic]

Thanks!
I'm familiar with the MPLAB config editor.
I guess because that was there I never thought much to look the the Pickit2 options.
But perhaps you're referring to the ME programmer.
I haven't used that since I had to let go of my PC with a serial port.
I thought I would try out the Pickit2 and that seemed to be working fine.
But just last week it died on me.
So I may end up getting one of the newer ME Labs units
Thanks!

[mpgmike]

I have an old Pickit2 I haven't used in years. I also have a Pickit3 that I haven't used in about a year. I usually use either the Pickit4 or ICD4, depending on the board. I have the ME Labs U2 Programmer that I use often when breadboarding. Lastly, I have the inexpensive Snap, which I bought only to verify it worked on circuits I sent to my partner (who also has one). If cheap is a priority, you might look into the Snap:

It programs anything Microchip sells, but
- It cannot power the project
- It requires LVP for programming

[dw_picbasic]

I was successful at doing this.
Thanks everyone for your kind help! :-]