Mark, so I have been messing around with the time and seems to work pretty smooth. I am running 12v power supply and have the controller set to 1.5a and 1600 pulse per revolution. It is very smooth and easily see how to adjust the timing to speed it up or slow it down. One thing at these settings there is not much torque. I can grab the spindle and dont have to hold to tight to get it to not turn and growl at me. Motor says it is rated at 2.8amps but doesn't list the voltage but many people are saying 24v is optimum and can run up to 48 volts. If I up the current on the driver will that give me more torque or do I have to also up the voltage. At this configuration I doubt this will move my parts on the converyer once I have it built.
Thanks