12F683, DT_INTs, and Lost pulses

[Fujimanme]

Hello Bo,

Were you able to get your 12F683 working? I am also using a 12F683 for a remote pressure sensor application but I am unable to compile the code as I get the interrupt error.

ERROR: Variable wsave2 position request 288 beyon RAM_END 191.

I have edited the DT_INTS-14.bas and left the wsave $20 and wsave $A0 enable, but alas still no go.

I know my setup is OK because if I grab an older code I was playing with years ago with DT Interrupts for 16F648A, it successfully compiles without any issues and I can program it to the PIC...

Cheers
Attila

[boroko]

I have been working on the bigger chips for this project to get some other features. I'm going back to the 12F683 to use what I learned. If I get an answer, I'll let you know.

Is it the INT on change that you are trying to use?

bo