hi tumble weed

with this configuration i cant see how the SS pin on a slave can ensure that it is in sync to CLK from master , even if the master controls the SS pin as the master is not sending data to the slave, and the normal full duplex coms can not be performed

the SS pin can be turned off in software for slave , but PPS seems to want it to be defined with its config for a slave MSSP , and i thinking i may need to assign it the SSP2- slave input

The slave SS even if it were turned on would need to be in a "selected State" at all times anyway from what i can see using this config

SS enable , tied to the master CLK is not going to work and still does not ensure data to CLK is in sync on slave ?


TOWLERG - ill take a look at the PPS tool

cheers

Sheldon