Snap programmer

[HenrikOlsson]

The executable is ipecmd.exe.
Are you saying you don't have that even though you have the full blown IPE tool installed and working?

/Henrik.

[Dick Ivers]

Henrick …. I tried the executable you suggested but it didn't lead to a useable result. Perhaps something else is needed ??

In any case I don't want to spend more time working on the snap programmer. It would only be a backup device for me and for that it works fine with the MPLAB X IPE.

[richard]

http://support.melabs.com/forum/picb...ity-board-pkob

i had issues with curiosity boards with cmdline from mcs , it worked ok using the tSBURxxxxxxxxx option the snap is pretty similar.

the number for your snap can be read from the MPLAB X IPE