Pickit 3 failed to program

[towlerg]

You don't need to use MPLabx/IPE for 16F88, you can use Pickit3.exe or CLI or even a PicKit2. Make sure you use the download option in the tools menu.

If you can use something else instead of 16F88 do so, I seem to recall several posts re. OSCCON and a couple of other things.

[Michael]

thanks George. I'll write that down and look at those options today. yes -- in my searches on 16F88 regarding all this I kept seeing "issues" regarding 16F88 and noted digikey doesn't even stock it now. oredered some 16F1847 because I need the memory but hope it isn't problematic as well ?

[Michael]

George --
How do I download pickit3.exe?

I went to tools on both mplab and the ipe and see download plug ins but don't see anything.

Google search shows a site for download that looks shady.


thanks

[Dave]

Michael, I have been using the 16F1847 for the past few years with the PicKit3 and PicKit4 as well as the ICD3 programmer's from MicroChip with there software and have had NO problems at all...

[mpgmike]

It just occurred to me that the really old PIC16F chips have an issue with the Vpp/MCLR voltage. As I recall, putting a 100 ohm resistor between the Vpp pin and the PICKit3 was a work-around.

[Michael]

It just occurred to me that the really old PIC16F chips have an issue with the Vpp/MCLR voltage. As I recall, putting a 100 ohm resistor between the Vpp pin and the PICKit3 was a work-around.

I have MCLR_OFF and using all of porta as outputs. MCLR has always confused me so simply, what should I be doing?
I have some 16F1847 coming today, so that's the chip I'll be using (same pinout as 16F88).

I need to get these things set up right for the peace of mind nothing in configuration is an issue. Also, new pickit3 coming today.

So, do I simply tie a 100 ohm to Vdd? Designate MCLR_ON? Do I set up the MCLR pin as an input?

You guys will have to forgive me but I'm an occasional user and all these setup details I don't retain.

[towlerg]

@michael PicKit3 GUI version http:// http://ww1.microchip.com/dow...on%20v3.10.zip , google PK3CMD.EXE for the command line version. Even better buy PickitPlus, it's well worth it.

[mpgmike]

In a previous post the question was posed, where to buy? I searched Microchip's site for PICKit3 and it appears they have discontinued selling it. There are probably many in inventory at DigiKey and other vendors. Their flagship programmer is now the PICKit4:

https://www.microchip.com/developmen...tails/PG164140

Their cost leader is the Snap programmer costing around $15 US.

https://www.microchip.com/developmen...tails/PG164100

[Michael]

Disregard post above about mclr.

What I need to know is this --

I've always had mclr tied to Vdd through a 4.7K with my earlier stuff but now with this 16F88 or 1847 I see the mclr is also porta.5 which has me thoroughly confused about the importance of mclr in the first place.

Right now I have all pins on porta as outputs.

?? what should I be doing? I can lose the porta.5 as an output if need be.

[Michael]

sorry about all this mindless gibber jabber. ran into this which clarifies much in plain english --
https://www.theengineeringprojects.c...-pic16f88.html

and wow, pretty nice site I've never seen before. !