IOC on the 27k40

[longpole001]

yes your correct, in that i could have turned off the IOC port trigger in neg or Pos , which ever was set , but the main toggling the IOC enable wont work as prev k22,k80 where it will stop the IOC being registered on k40 ,

as i am porting code from k80,k22 where the enable / disable of IOC is in many places in code , so having to ensure the IOCxF is cleared where i am disable/ enable, this stops a not required jump to the ISR to clear it , requires a bit of work

its just another step to do on the k40, as there is no main clear of the all IOCxF registers that i can see so far except by manual clearing,
nor a way to ensure a globle enable / disable that ensure that IOCxF wont register a change , after being setup in the IOCxN, IOCxP triggers

only a globle IOC status if triggered in in PIR0.4 as you pointed out in

that said with the flag set on the which IOC was triggered in each port, and if it was negative or positive , you can have a nice branch system for each IOC or group of IOC, possible in the ISR where it was not so great in the k22, k80 IOC system

sheldon

[mpgmike]

You can clear most flags from anywhere by:

IOCAF = 0
PIR1.5 = 0
...etc

Flags for UART require reading the RC1REG to clear the flag, but they are in the exception category.