As for the CONFIGs, try this for the PIC16F19176. It covers the defaults at the top and lists the options below. There is one for the K42 as well. In fact, you have it in your PBP3_1 Folder in your C:// drive.
PIC16F19176.txt
|
Re: After update serial programmer won't open
As for the CONFIGs, try this for the PIC16F19176. It covers the defaults at the top and lists the options below. There is one for the K42 as well. In fact, you have it in your PBP3_1 Folder in your C:// drive.
PIC16F19176.txt
|
Re: After update serial programmer won't open
Yes I have attempted to change the configs from the list using the config commands in the program itself. Since the programming part fails this does nothing. I make try to use the PK3 with the 16F19176.
|
Re: After update serial programmer won't open
Not that it helps much but the configs you see are presumably the Default/Unprogrammed Value listed in the datasheet.
George
Members who have read this thread : 1You do not have permission to view the list of names.
Posting Permissions
Bookmarks