First run with MPLAB X v4.05 + PicKit 2 + 18F2685 on my target (was perfectly working when devlopped under MPLAB 8 )
I am able to program the target and run it normally, not connected to PicKit 2.
I can launch the debug mode, halt and restart the program but each time I halt, MPLAB displays the message :
"No source code lines were found at current PC 0x178. Open program memory view to see instruction code disassembly."
My interpretation is that there is no way to follow the program execution at the PBP source level. Am I right ?
Also, I did not find any way to set up breakpoints. Double-click on source line does not work.
Again digging deeper and deeper !
MikeBZH
Bookmarks