Problem running from a 3v battery

[Bob_W]

Do you have the BOREN configuration bit set? If so, it looks like you'll be in brown out reset if you are under 3.65-4.00 volts.

[Bruce]

I think Bob has hit on the problem. You'll need to disable BOR, and stay below 10MHz oscillator frequency to run this PIC at 3V.

[Bob_W]

Actually, I think it was race to the finish between me and mister_e based on the timestamps. He said it also..... He must type faster than me : )

[mister_e]

hehe i had this impression of 'already said before' or "DEJA VUE' depending french ore english version you want to have.

Now that we are 3 with the same version/results... i must be true

[tbirchall]

I did try disabling the brown out and got interesting results. I think I mentioned above that I have a button triggering an interrupt that flashes an LED. Well, with brown out disabled, the LED constantly flashes. I don't have to press the button. (At least it runs, but not how I'd hoped.) I should have mentioned that I'm using the internal oscillator. Honestly, I'm not sure what it is running at. I think it defaults to 4MHz.

[mister_e]

Can you post your code?

[tbirchall]

The idea is that the chip sleeps until it gets an interrupt. This all works fine with 6 volts. I'm not setting the brown out to disabled here because I have to do it via the programmer (believe me, I've tried it both ways). I also set the internal oscillator with the programmer. It only has a setting for internal with or without the clock, not a frequency.

Code:

'----------------------------------------------------------------
' includes
'----------------------------------------------------------------
Include "modedefs.bas"

'----------------------------------------------------------------
' definitions
'----------------------------------------------------------------

'----------------------------------------------------------------
' constants
'----------------------------------------------------------------

'----------------------------------------------------------------
' variables
'----------------------------------------------------------------
 i      var     byte
 
'----------------------------------------------------------------
' init
'----------------------------------------------------------------
init:

    ' set all VARs to zero
    clear
    
    ' set configuration fuses
    @ DEVICE pic16F628A, WDT_OFF     ' turn watchdog timer off
    
    ' set up interrupt handler
    INTCON = %10010000
    OPTION_REG = 0
    on interrupt goto handleInterrupt
    
    low 7
    
    ' set portb/0 to input
    TRISB.0 = 1


'----------------------------------------------------------------
' main
'----------------------------------------------------------------
main:

    sleep 0
    pause 1
    
    ' blink an LED on pin RB7
    for i = 0 to 3
     
        high 7
        pause 300
        low 7
        pause 300
    
    next  
    
goto main

'----------------------------------------------------------------
' handleInterrupt
'----------------------------------------------------------------
disable
handleInterrupt:

    ' globally turn off interrupts
    INTCON.7 = 0
    
    ' clear the interrupt triggered flag
    INTCON.1 = 0
    resume
    
enable

END

Thanks!

-Tom