Using MCLR pin at Input

[aerostar]

"device pic12F683, intrc_osc_noclkout, wdt_on, mclr_on, protect_off"
"__config _INTRC_OSC_NOCLKOUT & _WDT_ON & _MCLRE_ON & _CP_OFF"

I believe to use the MCLRE pin as a digital input these 2 lines must read "mclr_off" and "_MCLRE_OFF"

Mike

But ONLY if you always want it OFF - and then have to remember to change it in the program, when you want it on.

The inc file is for general use, and idealy should be left unchanged, - you use the config statements in your program to over ride, as per the statement at top of post 3

@ DEVICE PIC12F683, intrc_osc_noclkout, wdt_on, mclr_off, protect_off , bod_on