Loading EEPROM

[CocaColaKid]

To load 365 in an eeprom location at programming time it would be:

data 109, 1

or

data %1101101,%1

This comes from breaking down the bits in the bytes of the word variable

decimal 365 = 0000 0001 0110 1101 binary

Since there are 8 bits to a byte, we now know that byte0 is 0110 1101b and byte1 is 0000 0001b. Convert these to decimal and you get 109 and 1 respectively. Both commands will accomplish the same thing.

You can also use:

write address, variable.Byte1
write address, variable.Byte0

and

read address, variable.Byte1
read address, variable.Byte0

This way can be done anywhere in the program. The DATA command is used to pre-load the eeprom location at time of programming.

[Darrel Taylor]

OR, if you didn't feel like breaking down every word sized number manualy, you can let the compiler help you out.

Days   CON    365
Dogs   CON   1024
Mice   CON  10000

EEPROM [Days&$FF, Days>>8, Dogs&$FF, Dogs>>8, Mice&$FF, Mice>>8]

Which would load ...

109, 1, 0, 4, 16, 39

It may seem a little awkward, but it's easier to make changes later on.

<br>

[Dick Ivers]

Thanks guys .... it works.

[Darrel Taylor]

And, I completely forgot about the WORD modifier for the DATA statement.

DATA WORD 365

This would also store it as ...

109, 1

<br>
I hope Bruce and Melanie weren't watching

[CocaColaKid]

Now that is something I didn't know! Man that really makes things a lot easier. I'll have to try that when I get back in to office.

[mister_e]

I hope Bruce and Melanie weren't watching

I'm not one of the above but... i saw you

KISS programming, is the best way. We often forget the base of it.