Upper case defines.
|
Re: blink a single led
Upper case defines.
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
|
Re: blink a single led
tks for your rePLY,
it is not the problem of program, nor breadboard? nor programmer?- it is suddenly dead
note that is well simulated in the proteus sofware
|
Re: blink a single led
If it is suddenly dead, I'd pay close attention to the breadboard connections and power supply.
You should also read up on READ MODIFY WRITE.
http://www.picbasic.co.uk/forum/show...d+modify+write
Last edited by Demon; - 28th November 2016 at 02:22.
My Creality Ender 3 S1 Plus is a giant paperweight that can't even be used as a boat anchor, cause I'd be fined for polluting our waterways with electronic devices.
Not as dumb as yesterday, but stupider than tomorrow!
|
Re: blink a single led
TKS for ur reply,
no way. power supply and every thing is ok
the chip was programmed a month ago is ok (on the bread board and on the circuit), just after last month, every thing is corrupted ( even on the sam breadboard connection or the same pcb)
i reprogram mplab and pbp but no help
|
Re: blink a single led
What has changed on the PC and programmer? In post#1 you said "programmer is just updated to 5.1 last night". if you mean that you updated the firmware in the programmer, then try reverting to the previous version.
BTW RMW hardly an issue with 1 sec between writes.
George
|
Re: blink a single led
The program writes the entire port anyway
|
Re: blink a single led
tks all,
after several attempts during a month, i tried to update the programmer firmware just a day ago.
Members who have read this thread : 0You do not have permission to view the list of names.
Posting Permissions
Bookmarks