Hello,
below is the super simple code
Code:
SIKO:
HIGH PORTA.0
HIGH PORTA.1
PAUSE 500
LOW PORTA.0
LOW PORTA.1
PAUSE 500
GOTO SIKO
There are leds connected to porta.1 and porta.0
The above code works, but only first line
If I place at first line code for PORTA.0 it works, but next line, for PORTA.1 does not works. If I swap them, then PORTA.1 will work, but PORTA.0 - not. But if I modify code a bit, to look like this, then it works properly.
SIKO:
HIGH PORTA.0
PAUSE 500
LOW PORTA.0
HIGH PORTA.1
PAUSE 500
LOW PORTA.1
GOTO SIKO
[/code]
Why this happens?
I have no TRISA, etc defined, as manual told us, HIGH/LOW statement in PBP does all necessary, so this is why it is so slow, but it appears not to work?
Bookmarks