UART communication problem

[picmilan]

Hello,

I am trying to use following code in a PIC18F14K50 to change configuration of a rn42 Bluetooth Module and it goes to command mode but then it gets stuck:


As an example I want to change name of bluetooth module and then reboot it.

DEFINE LOADER_USED 1
DEFINE HSER_RCSTA 90h
DEFINE HSER_TXSTA 24h
DEFINE HSER_BAUD 115200
DEFINE HSER_SPBRG 12 
DEFINE HSER_CLOERR 1

DEFINE OSC 24

ADCON0 = 011100
ADCON1 = 000000
ADCON2 = 110101

ANSEL = 001000      
ANSELH = 000011  

TRISC.4 = 0 
TRISC.0 = 0
TRISC.1 = 1
TRISB.5 = 1 
TRISB.7 = 0 

tx1 VAR PORTB.7
rx1 VAR PORTB.5
   
LED VAR PORTC.4

Mybutton VAR PORTC.1
  
mainloop:
   If Mybutton = 0 Then 
      HIGH LED      ' Turn on LED
            Hserout ["$$$"]                             'enter command mode
            Pause 100        
            Hserout ["SN,MyBT"]                       'Change name to MyBT
            Pause 100
            Hserout ["R,1"]                               'Reboot                      
      Pause 500
   Else
      LOW LED     ' Turn off LED
      Pause 500
   Endif
   Goto mainloop   ' Do it forever

I receive the data on serial monitor when I use a UART-USB converter so I know the strings are being sent.

However,the module starts blinking after $$$ but it doesn't perform the rest of commands.The similar Arduino code works without any problem.

Any idea why it doesn't work?

[HenrikOlsson]

Hi,
Never used the RN42 but shouldn't there be some sort of line termination characters after each command, like a LF or CR?
How else would it distinguish between for example MyBT and R, perhaps you wanted to change the name to MyBTR....


EDIT: Yeah, the command reference seems to indicate CR is what it expects.
/Henrik.

[aerostar]

You also have a typo, you have DEFINE HSER_CLOERR 1 it should be DEFINE HSER_CLROERR 1

[picmilan]

Hi,
Never used the RN42 but shouldn't there be some sort of line termination characters after each command, like a LF or CR?
How else would it distinguish between for example MyBT and R, perhaps you wanted to change the name to MyBTR....


EDIT: Yeah, the command reference seems to indicate CR is what it expects.
/Henrik.

AWESOME! That was the problem and it's working now.