MY bootloader config.ini is as follows but I cannot get it to work . in fact pll and bootloader seems to always give me grief
any ideas ?



Code:
; optional path information - default output folder is 
; user documents -> umcbuild... 
[PATH] 
Output=C:\MYBOOTLOADER
[TEMPLATE] 
;PIC18=..\src\18F\umc_loader.asm 
PIC16=..\src\16F\umc_loader.asm 
; device name and OSC... 
[MCU] 
Device=16F1825 
OSC=32000000 
;[USART] 
BAUDRATE = 19200 ; initial startup baudrate (default is 19200) 
BRGH16 = 1 ; 16 bit SPBRG support (default is OFF) 
; device configuration settings... 
[CONFIG] ;----- CONFIG1 Options -------------------------------------------------- 
__config        _CONFIG1,    _FOSC_INTOSC & _CP_OFF & _WDTE_ON  &  _PWRTE_ON  &  _MCLRE_ON  & _CLKOUTEN_OFF
__config      _CONFIG2, _PLLEN_ON & _LVP_OFF
; place startup code in here... 
[USERCODE] 
;banksel APFCON0 
; you need this as APFCON0 is at banked address. 
;bSf APFCON0,7 ;bSf APFCON0,2 
banksel ANSELC ; you need this as ANSELA is at banked address. 
clrf ANSELC
banksel OSCCON ; you need this as OSCCON is at banked address. 
movlw 0xf0 ; 8 mhz, pll enabled 
movwf OSCCON
banksel OSCSTAT
btfss OSCSTAT,6
goto $-1