TMR0 Longer time

[camerart]

Hi,
Yes, TMR0CON = %10001111 should be TMR0 enabled, prescaler assigned to it with ratio 1:256. If I where you I'd try it on real hardware, I'm willing to bet it's a simulator issue...

You do realise though that this forum is for MeLabs PBP compiler which is not the same as the Oshonsoft compiler, right? They're both BASIC, they're both for PIC but they are not the same.

/Henrik.

Hi H,

I am using the simulator, then putting it on the hardware, as the simulator doesn't actually support what I am doing

I realise that this is not an Oshonsoft support forum, I have had good replies from this forum, also there isn't much on Oshonsoft.

Thanks, C.

[camerart]

Correction. The simulator doesn't support [I]fully[I] what I'm doing.

[HenrikOlsson]

Hi,
Bit 3 of TMR0CON needs to be 0 in order to assign the prescaler to TMR0 - I got that backwards in my previous post, you had it correct in your original code.

TMR0CON = %10000111

The above have been tested on an 18F4431 (actual hardware) and it does work.

/Henrik.

[camerart]

Hi,
Bit 3 of TMR0CON needs to be 0 in order to assign the prescaler to TMR0 - I got that backwards in my previous post, you had it correct in your original code.

TMR0CON = %10000111

The above have been tested on an 18F4431 (actual hardware) and it does work.

/Henrik.

Hi H,

Thanks very much for re-checking. I spend many hours chasing small errors like that. In fact, I couldn't get TMR0 to work because I removed the TIME = 1 with INTCON.TMR0IF = 1, and as the TMR0 is count down not up, this was also backwards. TMR0 is now working.

Thanks, C.