New WiFi Module

[dhouston]

Thanks - I had clicked that tab but nothing happened.

[aerostar]

http://www.wiznettechnology.com/Sub_...=&pid=1132#tab

Links do work, justdownloaded pdf.

[dhouston]

When I click the link, the page jumps as if scrolling down a few lines, but nothing else. Clicking a second time loads the linked page.

[dhouston]

Given the low cost of the WizNET devices, I'll try to design a shield that can support the WizFi810 and the Wiz107SR. They are not quite as easy to use as the Connect One modules nor do they have SMTP/POP3 and other protocols built-in but users might be able to adapt Henrik's low level code (once completed) to work with these.

[dhouston]

It looks like the Wiz105SR is their only ethernet-to-serial module without either an RS232 or RS485 transceiver. It has a SMH header on top of the board which would make it hard to use with a shield that also supports the WizFi210 but I may buy one to see how difficult it would be to modify.

[dhouston]

That should have read SMD. Anyway, the Wiz105SR just barely fits on a shield PCB with enough room left over to squeeze in a 2x6 header that can connect to the module via a ribbon cable. So, while I'm waiting on answers to a couple of questions, I'm fairly sure I'll design a shield for the Wiz105SR and the WizFi210. Both are among the least expensive modules of these types. If so, I'll drop the shield design for the Tibbo modules - I really don't like how long Tibbo took with firmware updates nor do I like the Goldbergian interconnect method they used between the EM500 and GA1000 and flash.

[Sneaky-geek]

Hi Dave,
I looking at this also. I have a project in mind that would appeal to the hams here AND elsewhere.
It is a wireless UNencrypted link using either channel 1 OR 6. The reasons for this is to increase range.
Any thoughts or suggestions would be very helpful.

Terry K9HA