Quote Originally Posted by gunayburak View Post
So there is no use of the lsb of the control bit , then it's determined by the command's itself ... I mean if it is I2CREAD op then it automatically determines this bit itself ... Am I correct ? I'll give it a try once more by using

Code:
i2cREAD SDA,SCL,%11010000,$00,var
At least I may read the control or the status register ...

Thanks ..
No luck with that either ... I have even pulled the scl and sda up with 4.7 k resistors ... neither I can write nor read the control and status registers ... 😕