ICD2 - problems

[leonel]

I already find out what was the problem...
I did a bad connection

[tiing2020]

hi,
i have problem with my ICD2 programmer. i dont know how to solve it.
when i using MPLAB7.2, it give me an error message, the error as shown in below
[
CDWarn0054: MPLAB IDE has lost communications with the MPLAB ICD 2. Would you like to attempt to reconnect? Connecting to MPLAB ICD 2 ICD0021: Unable to connect with MPLAB ICD 2 MPLAB ICD 2 Ready
]

i hope everyone here can help me to solve it.

thanks!

[RodSTAR]

I already find out what was the problem...
I did a bad connection

HELLO
Please, could you tell us what was the bad connection and how did you solve it? i can't make it go by a week and I've found no solution.

[mackrackit]

That post is around 5 years old and it has been around 3 years since the OP has been here....

What king of problems are you having?

[leonel]

It was because i was using one programming pin (i do not remember which one) as dual mode - input and programming. I know it's possible to do that, although i had problems when doing that... i suppose it was related with capacitance problems. Are you using as dual mode - input/output and programming?

Best regards,
Leonel