A/D Conversion Clock Select bits confussion ..

[gunayburak]

Grazie tante per la risposta cara aratti ..

[Heckler]

I remember saving a link to this... http://www.edaboard.com/nextoldesttoentry1570.html
page. Be sure to hit the "next" button at the bottom of the page where there is discussion of acquisition time.

hope this helps you.

[Heckler]

I remember saving a link to this... http://www.edaboard.com/nextoldesttoentry1570.html
page. Be sure to hit the "next" button at the bottom of the page to go to Part 2 where there is discussion of acquisition time.

Possibly something of value there.

[gunayburak]

The only part I cant understand is the line he somehow calculated 40 + 38.4 us = 78.4 uS .. where did that 40 come from ?

[aratti]

40 us is the value the author arbitrarely gives as acquisition time "sampleus parameter".

Remember:

A too high acquisition time will give issues when the analog input approch the V(ref+)

A too low acquisition time will give issues when the analog input approch the zero

So, if you do not see any issues in your reading at the extreme of the reading field then the acquisition time used is correct!

Ciao, complimenti per il tuo italiano!

Al.

[tumbleweed]

A too high acquisition time will give issues when the analog input approch the V(ref+)
A too low acquisition time will give issues when the analog input approch the zero

Where do you get this from?

The aquisition time is the MINIMUM amount of time you have to wait for the holding capacitor (and it's RC network) to fully charge/discharge to the voltage level you're sampling.

If you set the acquisition time too low then you won't have allowed enough time for the charge on the capacitor to reach the desired level, and you'll get an incorrect conversion. It doesn't matter so much if the input is near Vref or zero, it'll be wrong.

If you're measuring a DC voltage, there is no "too high" an aquisition time.

[aratti]

Where do you get this from?

From the charging function of a capacitor!

Al.

[tumbleweed]

So you're saying that if you wait too long the voltage on your sampling capacitor will be wrong?

If you put a small RC network across a voltage source, what will the voltage across the capacitor be if you wait a second? A minute? An hour?