USART2 setting for 1MHzCPU + 4PLL

[longpole001]

using a 18f46k80 , but i would think any of simular series would have this as well

again it very rare for me to use a pic at such a low osc rate and this where i found the problem for the calculations

[Tabsoft]

Can you post your currently used config bits, OSCCON, OSCCON2 and OSCTUNE settings?

[richard]

from the data sheet osc section

Section 3.6.2 “INTPLL Modes”
. Care should be taken
that the PLL is enabled only if the HF-INTOSC
postscaler is configured for 4 MHz, 8 MHz or 16 MHz

[Tabsoft]

Just where I was headed Richard, hence my question.
The registers/config bits would show how he is setting up the clock.